- How do you engage the blades on a Craftsman riding lawn mower?
- Why wont my blades engage on my Craftsman riding mower?
- How do I fix the throttle cable on my lawn mower?
- How do you adjust the throttle on a Craftsman riding lawn mower?
- What is the throttle on a lawn mower?
- Why won't my riding lawn mower blades engage?
- Why does my lawn mower stall when I engage the blades?
- How do you engage the blade on a riding lawn mower?
- Why did my mower blades stop working?
How do you engage the blades on a Craftsman riding lawn mower?
Find the plunger at the top of the attachment lift lever. Press the plunger inward with your thumb, and move the attachment lift lever back, or toward you, to lower the cutting blade. Release the plunger and attachment lift lever. Pull the attachment clutch switch outward to "Engage" to make the cutting blade rotate.
Why wont my blades engage on my Craftsman riding mower?
If the PTO clutch is not getting power, if the clutch solenoid is defective, or if the clutch is worn out, the lawn mower blades will not engage. The PTO clutch is not repairable—if the clutch is defective, you must replace it. The PTO switch provides power to the PTO clutch.
How do I fix the throttle cable on my lawn mower?
How to Replace & Adjust the Throttle Cable on a Lawnmower
- Remove the cable housings using a pair of pliers. The housings will swivel off the base and slide down the cable. ...
- Thread the cable wire through the housing. ...
- Slide the cable through the housing and then into the handle unit to attach it to the throttle handle. ...
- Test the tension by replacing the throttle.
How do you adjust the throttle on a Craftsman riding lawn mower?
Set the throttle to fast and start the mower engine. Turn the high speed screw first clockwise until the engine slows, then counterclockwise until it slows. Locate the center point where the engine idles best. Move the throttle from slow to fast then back to slow to test the adjustment.
What is the throttle on a lawn mower?
The throttle of your lawn mower is the component that actually controls the engine speed. It is used to start the engine and also helps control the speed of the blades while you are mowing your lawn. ... It does this through pulling on a throttle cable, which controls the speed of the engine.
Why won't my riding lawn mower blades engage?
Top Reasons why your blades will not engage on your riding mower or tractor: Belt-the number one cause for your blades not to engage is that your belt is either stretched or loose causing it to slip or fall off completely. Belt could have snapped also.
Why does my lawn mower stall when I engage the blades?
If a pulley doesn't spin freely, it can cause the engine to die when the blades are engaged. ... The pulleys in your lawn tractor are driven by the drive belt, and turn the spindles. If a pulley doesn't spin freely, it can cause the engine to die when the blades are engaged.
How do you engage the blade on a riding lawn mower?
How to Engage Lawn Mower Blades on a John Deere
- Turn the key to the "on" position, advance the throttle to half speed and allow the engine to warm up for 2 minutes.
- Lower the mower to the desired cutting height. Check for any debris around the mower.
- Engage the mower blades; push the lever to the right of the steering wheel all the way forward.
Why did my mower blades stop working?
If your mower blades will not turn after the blade controls have been engaged, your deck belt may be broken. The deck is located directly under the operators seat. This belt spins the mowers blades and runs through a pulley system of idlers. ... If the belt has snapped, it will need to be replaced.