Fuse

No power to bike

No power to bike
  • 2493
  • Leo Dorsey

Take the battery to an auto parts store and have them test it. If the battery fails their test, replace the battery. Next, check the main fuse, usually on the same cable as the positive battery connector. ... Then check the fuses in fuse box, doing as with the main fuse if any are blown.

  1. Where is the main fuse on a motorcycle?
  2. Where is the main fuse located?
  3. How do you bypass a motorcycle starter relay?
  4. How do you tell if a fuse is blown?
  5. What to do if a fuse has tripped?
  6. Is there a fuse for the battery?
  7. Is it OK to bypass starter relay?
  8. Can I bypass my starter relay?
  9. When I try to start my motorcycle it just clicks?

Where is the main fuse on a motorcycle?

Normally you would install the main fuse on the live side of the battery in-line with the wire which goes from the battery and up to the ammeter connections for distribution to the lights and other accessories.

Where is the main fuse located?

If the blown fuse is a main fuse, the main fuse block is usually located at the top of the fuse box.

How do you bypass a motorcycle starter relay?

How do you bypass a motorcycle starter?

  1. Locate the starter motor under the vehicle.
  2. Locate the two metal contacts on the back of the starter solenoid.
  3. Place the metal blade of an insulated screwdriver across both metal contacts.
  4. Get a friend to help you by turning on the ignition with the key.
  5. Listen to the starter motor.

How do you tell if a fuse is blown?

Remove the fuse from its holder. In some cases you may need a small screwdriver to unscrew the fuse holder cap. Look at the fuse wire. If there is a visible gap in the wire or a dark or metallic smear inside the glass then the fuse is blown and needs to be replaced.

What to do if a fuse has tripped?

Unplug all appliances on that problem circuit and switch off any immersion heaters (if you have one). Switch the tripped switch to the ON position and plug in the appliances one by one until the trip goes again. Leave that appliance unplugged, and have it repaired by a qualified electrician.

Is there a fuse for the battery?

You may need to replace the grounding cable and/or connections. A blown main fuse at the battery is likely NOT the reason for all your car's problems. The fuse is there to protect the wiring harness in the event of a severe short-circuit somewhere in your car's wiring.

Is it OK to bypass starter relay?

Not a great idea. That starter and battery cable is a big wire pulling a lot of current through it. What makes you wish to do this? You are better off momentarily bypassing it with an insulated screwdriver as suggested if you just want to test or otherwise run the starter.

Can I bypass my starter relay?

Place the metal blade of an insulated screwdriver across both metal contacts. This bypasses the solenoid and creates a direct connection between the starter motor and the ignition switch.

When I try to start my motorcycle it just clicks?

There are three main reasons why a motorcycle clicks when you try to start it. The first and most common reason is because of a dead battery. The second reason could be due to a bad starter. The third most common but less likely reason the motorcycle is clicking could be due to a seized engine.

Coolant flush - didn't take specified amount of coolant
How much coolant do I need for a flush?How much for a coolant flush and fill?What happens if you don't have enough coolant?Why do I have to keep toppi...
How to fix stripped tire valve stem?
How do you fix a stripped valve stem?Can a valve stem on a tire be fixed?How much does it cost to replace a valve stem on a tire?Can you replace a val...
Engine problems 2001 Toyota Highlander
What problems do Toyota Highlanders have?Are 2001 Toyota Highlanders reliable?How many miles will a 2001 Toyota Highlander last?What year is the most ...

Yet No Comments