Motorcycle

I have a custom chopper motorcycle wiring issue

I have a custom chopper motorcycle wiring issue
  • 3799
  • Mark Baldwin
  1. How do you check motorcycle wires?
  2. How long does it take to rewire a motorcycle?
  3. What could cause a motorcycle not to start?
  4. Will a motorcycle start with a bad stator?

How do you check motorcycle wires?

First measure the resistance between the primary wire that comes from the CDI box and the ground or ground wire. The resistance should measure around . 5 to 1.5 Ohms. If that checks out, you can then measure the resistance between the secondary wire (plug wire), w hich should measure in the thousands.

How long does it take to rewire a motorcycle?

Re: How Long Should It Take a Professional to Rewire (Complete) My CB550? Depending upon the extent of the work, I'd say best case 4 hours, worst case 2 days. The latter would be having to essentially re-run the main harness and crimp new connectors, wrap and route. Repair the major sub harnesses too.

What could cause a motorcycle not to start?

One potential issue that might be keeping your motorcycle from starting up is a clogged petcock. The petcock is a fuel control valve. It controls the gas flow between off, on, and reserve settings. Clogged petcocks are a common issue that riders often bring up in forums.

Will a motorcycle start with a bad stator?

If the stator is bad, the bike won't run at all. The stator generates energy for spark. Assuming the air cleaner is clean and other general maintenance has been performed, if the bike won't kick start but runs as you state, the problem is probably either the spark plug and/or fuel delivery.

Cracks near the tyre tread. Are they concerning?
Small cracks on the tread blocks of the tyre are a sign of normal wear and tear and aren't generally anything that you need to worry about. Deeper cra...
Can we use fluid designed for wet clutched on a dry clutch DCT?
What is wet clutch DCT?What is DCT transmission fluid?What is the difference between a wet clutch and a dry clutch?Which type of clutch can be dry or ...
S10 won't crank
While there are a variety of reasons your Chevrolet S10 won't start, the most common 3 are a dead battery, an alternator problem, or failed starter.Wh...

Yet No Comments